GIS

Maintenance and Economics of GIS

Maintenance of GIS: Experience has shown that the internal parts of Gas Insulated Substation are so well protected inside the…

5 years ago

Installation, Operation and Interlocks For GIS

Installation: The GIS is usually installed on a monolithic concrete pad or the floor of a building. It is most…

5 years ago

Electrical and Physical Arrangement, Grounding, Testing For GIS

Electrical and Physical Arrangement: For any electrical one-line diagram there are usually several possible physical arrangements. The shape of the…

5 years ago

Gas Monitor System, Compartments and Zones for GIS

Gas Monitor System: The insulating and interrupting capability of the SF6 gas depends on the density of the SF6 gas…

5 years ago

Surge Arrester and Control System for GIS

Surge Arrester: Zinc oxide surge arrester elements suitable for immersion in SF6 are supported by an insulating cylinder inside a…

5 years ago

Bus and Air, Cable, Direct Transformer Connection For GIS

Bus: To connect GIS modules that are not directly connected to each other, and SF6 bus consisting of an inner…

5 years ago

Circuit Breaker, Current And Voltage Transformers, Disconnect And Ground Switches For GIS

Circuit Breaker: GIS uses essentially the same dead tank SF6 puffer circuit breakers used in AIS. Instead of SF6 -to-air…

5 years ago

Construction and Service Life of GIS Substation

GIS is assembled of standard equipment modules (circuit breaker, current transformers, voltage transformers, disconnect and ground switches, interconnecting bus, surge…

5 years ago

GIS – Gas Insulated Substations

A gas-insulated substation (GIS) uses a superior dielectric gas, SF6, at moderate pressure for phase-to-phase and phase-to-ground insulation. The high…

5 years ago

ABOUT US | TERM & CONDITIONS | PRIVACY POLICY

 

© 2017 - 2022, By An Electrical Engineer