Electrical Substation is most common word for an Electrical Engineer or Engineering Student. You will find all practical problem and solution for making and maintain an electrical substation in real life.
Current Transformers (CT) are the devices in which the secondary current used for calculation is proportional to the primary current…
Maintenance of GIS: Experience has shown that the internal parts of Gas Insulated Substation are so well protected inside the…
Installation: The GIS is usually installed on a monolithic concrete pad or the floor of a building. It is most…
Electrical and Physical Arrangement: For any electrical one-line diagram there are usually several possible physical arrangements. The shape of the…
Gas Monitor System: The insulating and interrupting capability of the SF6 gas depends on the density of the SF6 gas…
Surge Arrester: Zinc oxide surge arrester elements suitable for immersion in SF6 are supported by an insulating cylinder inside a…
Bus: To connect GIS modules that are not directly connected to each other, and SF6 bus consisting of an inner…
Circuit Breaker: GIS uses essentially the same dead tank SF6 puffer circuit breakers used in AIS. Instead of SF6 -to-air…
GIS is assembled of standard equipment modules (circuit breaker, current transformers, voltage transformers, disconnect and ground switches, interconnecting bus, surge…
A gas-insulated substation (GIS) uses a superior dielectric gas, SF6, at moderate pressure for phase-to-phase and phase-to-ground insulation. The high…
ABOUT US | TERM & CONDITIONS | PRIVACY POLICY
© 2017 - 2022, By An Electrical Engineer
